Anti-slip Epoxy Floor Paint heavy duty Maydos Coating (ALT-ET)
ALT-ET is a two-component anti-slip epoxy floor paint. Nice appearance, dust & corrosion resistant and easy to clean. The whole coating system can bond well with the solid base and has good abrasion and wearing resistance.
Meanwhile, it is resistant to compression and impact and can stand heavy-duty load to a certain extent.
Technical Data
| Color | Any solid color |
| Mix Ratio | JD-148A:JD-148B=5:1 |
| Compressive strength (Mpa) | ≥85 |
| Impact resistance strength (Kg·cm) | 65 |
| Flexural strength (Mpa) | ≥75 |
| Adhesive force grade | 1 |
| Hardness (Shore D) | ≥83 |
| Abrasion resistance(750g/1000r, zero gravity, g) | ≤0.03 |
| Resistance to engine oil, diesel oil for 60 days | Passed |
| Resistance to 50% sulfuric acid for 20 days | Passed |
| Resistance to 25% Sodium hydroxide for 30 days | Passed |
| Resistance to toluene, ethanol for 60 days | Passed |
| Service life | 8 Years |
Feature
common floor paint
Application
Where to Use:
It is mainly used for concrete surface where has compression & wearing resistance and anti-dust and corrosion requirement, such as Car Parking,ndustry workshop, office, warehouse, foodstuff factory etc.
Application instructions:
Application instructions
| Surface preparation | Correct substrate preparation is critical for optimum performance.
Surface should be sound, clean, dry and free from loose particles,oil,grease,and other contaminants. |
| Primer | Prepare a barrel, pour JD-D10A and JD-D10B in it based on 1:1.
Stir the mixture well and then apply it with roller or trowel. The reference consumption is 0.15kg/m². The main purpose of this primer is to seal the substrate completely and avoid air-bubbles inthe body coat. A second coat may be required depending on the oil absorption condition of substrate. The recoat time is about 8 hours. |
| Inspection standard for the primer: even film with certain brightness. | |
| Undercoat | Mix WTP-MA and WTP MB based on 5:1 first,
then add quartz powder (1/2 of the mixture of A and B) into the mixture, stir it well and apply with trowel. The consumption quantity of A and B is 0.5kg /sqm. You can do it one coat at one time or two coats at two times. In the second case, the application interval is about 8 hours at 25 degrees. Sand the first layer, clean it and then apply the second layer. After the whole application, wait another 8 hours, grind it, clean the sanding dust and then continue the next procedure. |
| Inspection standard for the undercoat: Non-sticky to hand, no softening, no nail print if you scratch the surface. | |
| Top coat | Mix JD-2000A and JD-2000 B based on 5:1 and then apply the mixture with spatula.
The consumption quantity is 1.0kg/sqm. |
| Maintenance | 5-7 days. Don’t put the floor into use or wash it with water or other chemicals. |
epoxy floor paint tools
epoxy floor paint color chart
Project case
epoxy floor paint project case
Package
epoxy floor paint
